What para Look para en Microphone Array Matching
Allí son many types of microphones used en presentation situations: tabletop microphones, handheld microphones, ceiling microphones, y inconspicuous clip-EN y headset microphones. El podium microphone EN El Conferencia table can certainly represent Un elegant design feature - y incidentally también emphasizes El special importance of El person sitting behind Ello.
Among other things, UN
Analog Array Microphone Unidad
Matching Issues
El más important feature ese must ser present en UN microphone array device es microphone matching. All El microphones en El array must ser similar y closely matched, y en Algún ways identical, en order para El array UN get UN good recording. Otherwise, Usted may run into El following problems:
one of El microphones en El microphone array tiene UN much higher gain.
microphones son out of phase, ASÍ QUE one microphone records before El other.
One microphone picks up sound from all directions, while El other picks up sound from solo UN single direction.
El above situation can lead UN Algún terrible consequences. Por Lo Tanto, El three aspects of microphone arrays ese need UN ser considered para matching son directionality, sensitivity phase.
Directionality
Directionality refers UN El direction en que Ello can pick up sound. Algún microphones can solo pick up sound from one direction, yo.e. unidirectional microphones. Other microphones son built ASÍ QUE ese ellos can pick up sound from all directions, omnidirectional microphones. Cuando edificio Un array microphone, all microphones must tener El igual directionality.
Having one microphone pick up sound from solo one direction y another microphone pick up sound from all directions sería result en UN disastrous, unbalanced recording. Este es largely undesirable, except en Algún special cases donde Este sería occur.

Sensitivity
Sensitivity es another aspect of UN microphone array ese must ser matched. Sensitivity es El gain ese El microphone picks up Cuando recording UN signal. El sensitivity of UN microphone array device must ser closely matched, otherwise one microphone será ser louder than El other, resulting en Un unbalanced recording.
Usually El maximum sensitivity difference allowed para Un array microphone es ±1.5 dB, y El microphone sensitivity difference para UN microphone es no más than 3 dB.
Phasing
Phase es El last important aspect of UN microphone array ese must ser matched. Phase es El reference degree line para Cuando UN microphone starts recording, meaning ese Ello determines Cuando all El microphones en El array start y stop recording. If El microphones tener muy different phases, ellos será record El signal en different times. Este será cause El recording UN ser out of sync. Again, Este es largely undesirable. Ello es desired ese El microphones record El signals simultaneously ASÍ QUE ese Allí es no delay between El signals.
Solo like sensitivity, El phase difference between microphones must tener UN maximum allowable tolerance. Este difference es typically ±1.5 degrees UN ensure ese El signals son recorded simultaneously ASÍ QUE ese harmonious recording es achieved.
Usted can check nuestro
